You are here
-
Aluminum Rod & Wires
-
Continuous Cast Aluminum / Alloy Rods
-
Hard Drawn Aluminum / Alloy Wires
-
-
Overhead Line Conductors
-
High Thermal and HTLS Conductors
-
Special Alloy Conductors
-
-
Aluminium Clad Steel
-
Extruded Products
Multi-void Tubes
| Aluminium 1050 | |
|---|---|
| Minimum Width of MV Tube | 10.00mm |
| Maximum Width of MV Tube | 50.00mm |
| Minimum Cross Section Area | 20.00mm2 |
| Maximum Cross Section Area | 280.00mm2 |
| Minimum Wall Thickness | 0.50mm |
| Maximum Wall Thickness | 1.00mm |
| Minimum Depth of MV Tube | 4.00mm |
| Minimum Gallery Pitch | 3.00mm |
| Maximum Tolerance of Overall Width | On < 25.00mm ±0.10mm |
| Maximum Tolerance of Overall Width | On > 25.00mm ±0.15mm |
| Maximum Tolerance of Overall Width | On > 40.00mm ±0.20mm |
| Maximum Tolerance of Thickness | On < 0.80mm ±0.05mm |
| Minimum Tolerance of Thickness | On > 0.08mm ±0.08mm |
| Aluminium Alloy 3030 | |
| Minimum Width of MV Tube | 12.00mm |
| Maximum Width of MV Tube | 40.00mm |
| Minimum Cross Section Area | 25.00mm2 |
| Maximum Cross Section Area | 260.00mm2 |
| Minimum Wall Thickness | 0.60mm |
| Maximum Wall Thickness | 1.00mm |
| Minimum Depth of MV Tube | 4.00mm |
| Minimum Gallery Pitch | 3.00mm |
| Maximum Tolerance of Overall Width | On < 25.00mm ±0.10mm |
| Maximum Tolerance of Overall Width | On > 25.00mm ±0.15mm |
| Maximum Tolerance of Overall Width | On > 40.00mm ±0.20mm |
| Minimum Tolerance of Thickness | On < 0.80mm ±0.05mm |
| Minimum Tolerance of Thickness | On > 0.08mm ±0.08mm |
Note: All the data set out in this page is given for information purposes and Midal will not be held responsible for its accuracy.
